- “Clicking means the igniter is fine — look at the gas and the ports”
- “A burner cap seated slightly off after cleaning is very common”
- “All burners clicking when one is turned is normal on these”
Symptom
Electrolux gas burner will not light
The igniter is working, so the problem is the gas or the port rather than the spark. On a sealed burner the usual pair is a clogged port or a cap that went back very slightly out of true after somebody cleaned the hob — and both are free to correct. If one burner lights and another does not, you have already done most of the diagnosis yourself.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Three ordinary causes
What this usually turns out to be
Cheapest and commonest first, which is also the order we check them in. They sit hundreds of dollars apart, and only the unit settles which one is yours.
-
The cap is not seated
After a clean, and the commonest cause. The flame cannot establish across a cap that is a millimeter out.
Gas burner and igniter repair from $145 -
The ports are blocked
Boil-over, then heat, then carbon. A pin clears them; a brush moves the debris around.
Gas burner and igniter repair from $145 -
The igniter or its switch has failed
Where nothing clicks at all on any burner, it is the module or the supply rather than one burner.
Gas burner and igniter repair from $145
In five minutes
Before you call anybody
None of it needs tools, and all of it makes the visit shorter.
-
01
Lift and re-seat the cap
Free, thirty seconds, and it is frequently the whole answer.
-
02
Clear every port with a pin
A partly cleared burner lights unevenly and gets blamed on the igniter.
-
03
Test another burner
It separates one burner from the whole module immediately.
How it shows up
What people describe when they call
A shortcut
Narrow it down before anybody arrives
A description of the behaviour leaves a few possible causes. A code names the subsystem before anybody opens anything, which is why it is worth photographing before it clears.
In more detail
About Electrolux gas burner will not light
What to do in the next ten minutes
Turn the burner off. Lift the cap and check it sits square — it only goes on one way and it is easy to get wrong after cleaning. Clear the ports with a pin rather than a brush. Try another burner to confirm the igniter module is working.
Why the smell of gas changes the advice
Everything on this page assumes you can smell nothing. If you can smell gas — at the appliance, in the cabinet below, anywhere in the room — stop, turn the supply off at the valve, open a window, and do not operate any switch. That is not a repair question and this is not the page for it. Call the utility's emergency line first and us afterwards.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Electrolux gas burner will not light
All the burners click when I turn one.
That is normal on these. The module fires every igniter and only the burner with gas lights.
It lights and then goes out after a few seconds.
Different problem, and usually the flame sensor or the thermocouple — the burner lights and nothing confirms it, so the gas is shut off again.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name