Service
Electrolux gas burner and igniter repair
Clicking that never lights, a burner that lights and goes out, or a flame that is yellow and lazy where its neighbors are blue. On a sealed burner the ordinary pair is a clogged port or a cap that went back very slightly out of true after a clean, and both are ordinary work. The gas rangetop and the drop-in cooktops on this badge share burner design, so the diagnosis carries across — the access does not.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $145
After a diagnostic from $95, which comes off the bill when you go ahead.
or call (305) 912-9018
Diagnostic
From $95, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Lift the cap and sit it square
It only goes on one way and it is easy to get wrong after cleaning. This is the free answer and it is often the right one.
-
02
Clear the ports properly
A pin rather than a brush, and every port. A partly cleared burner lights unevenly and gets blamed on the igniter.
-
03
Test the igniter and the switch separately
All burners clicking when one is turned is normal on these. None clicking at all is the module or the switch.
Applies to
The Electrolux units we carry this work out on
-
Induction · dual-fuel · gas, 30 and 36 inch Electrolux range repair in Miami
Six ranges, at 30 and 36 inches, in three fuels: induction, dual-fuel and front-control gas. There is no electric coil range and no plain radiant range in this line at all — which is precisely the machine that fills the rental kitchens its sister badge sells into. A 36-inch range is a deliberate purchase and usually the center of the room, and that shows in how these calls come in: people describe what the range was doing when it stopped, not just that it stopped. Almost every published range code on this badge is a name plus a power cycle, so the honest page says that rather than inventing a checklist.
- Six ranges — induction, dual-fuel and gas, at 30 and 36 inches
- No electric coil and no plain radiant range is built on this badge
- Most published range codes are a name and a thirty-second power cycle
-
Induction and gas · plus a 36-inch rangetop Electrolux cooktop repair in Miami
Five units: three gas and two induction, at 30 and 36 inches. There is no electric radiant cooktop and no coil unit in this line — the glass top you may be standing over is induction, and it fails in ways a radiant top does not. One of the five is a 36-inch gas **rangetop**, which is a different appliance from a cooktop and must not be confused with one: it is a free-standing cooking surface with a raised back, designed to sit in a run with an oven elsewhere. Telling us which of the two you have saves a wasted visit, because almost nothing is shared between them.
- Five units — three gas and two induction, at 30 and 36 inches
- No electric radiant or coil cooktop exists on this badge
- One of the five is a rangetop, which is a different appliance
In more detail
About Electrolux gas burner and igniter repair
Most of this is free and follows a clean
A burner cap that went back very slightly out of true, or ports that were never fully cleared, account for most of what arrives as a failed igniter. Both are the direct consequence of somebody cleaning the hob, which is why this complaint so often starts the week after. The cap only fits one way, a pin clears the ports properly where a brush moves the debris around, and trying another burner separates one burner from the whole module in seconds.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Electrolux gas burner and igniter repair
All the burners click when I turn one on.
That is normal on these. The module fires every igniter and only the burner with gas at it actually lights.
It lights and goes out after a few seconds.
Different problem. The burner lights and nothing confirms the flame, so the gas is shut off again — that is the flame sensor or the thermocouple rather than the igniter.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name