Service
Electrolux washer suspension and bearing repair
A roar on spin that rises with speed, a drum that moves more than it should when you push it, or rust-colored water appearing where there was none. Bearings are the repair on a front loader where we are most likely to advise against it, and we would rather say that before the work than halfway through. On a 700 Series machine in a building laundry it is usually worth doing; on an eight-year-old compact it usually is not.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $275
After a diagnostic from $95, which comes off the bill when you go ahead.
or call (305) 912-9018
Diagnostic
From $95, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Spin it empty and listen through the speed range
Bearing noise tracks the drum speed. A noise that does not change is something else entirely, and cheaper.
-
02
Push and pull the drum at the front
Movement at the drum front means the bearing has gone, and the seal behind it usually went first.
-
03
Price it against the machine, honestly
This is the repair where the arithmetic matters most, and a company that does not put it in front of you is a company selling a job.
Applies to
The Electrolux units we carry this work out on
-
Front load only · 300 to 700 Series Electrolux washer repair in Miami
Six machines, and every one of them is a front loader — 300, 400, 500, 600 and 700 Series plus a 24-inch compact. This make builds no top-load washer at all, which is the clearest single difference between this badge and the mass-market half of the same group. Laundry is the deep end of this line rather than an afterthought: 22 machines across washers, dryers and towers against six refrigerators. The maker publishes eight washer codes with real procedures behind them, and — worth knowing before you are quoted — three of those eight are installation problems rather than failures.
- Six washers, all front-load, 300 through 700 Series plus a 24-inch compact
- No top loader is built on this badge at all
- Three of the eight published codes are installation problems, not failures
In more detail
About Electrolux washer suspension and bearing repair
The repair we most often advise against
It is worth putting that at the top rather than burying it. Bearings on a front loader are a long job, and on an older or a compact machine the cost lands close enough to a replacement that doing it is usually the wrong call. On a 700 Series machine in a building laundry it is usually right. We would rather have that conversation before the work than halfway through it, and the figure on this page is written high precisely so it cannot hide.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Electrolux washer suspension and bearing repair
How do I know it is the bearing?
A roar on spin that rises with the drum speed, and movement at the front of the drum when you push and pull it. A noise that does not change with speed is something else, and cheaper.
There is rust-colored water in the drum.
Then the seal went before the bearing did, and the bearing has been running wet for a while. That usually settles the repair-or-replace question on its own.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name