Service
Electrolux washer drain pump replacement
The machine fills, washes and then stops with water in the drum, or shows E21 for a pump-out taking too long. This maker's own first answer is not a part: a kinked drain hose, and in a laundry closet where the machine has been pushed back to let the door close, the machine has folded its own hose. After that it is the pump filter — which on a household washing beach towels collects sand as reliably as lint — and only then the pump itself.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
Before you read on
What this job costs and how it is agreed
A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.
Starts at
from $155
After a diagnostic from $95, which comes off the bill when you go ahead.
or call (305) 912-9018
Diagnostic
From $95, credited to the repair
The price
In writing, before anything is opened
Warranty
On the labor we performed
On the visit
How this visit actually goes
The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.
-
01
Walk the drain hose with the machine pulled out
A fold behind the cabinet is what this maker names first and it costs nothing to rule out.
-
02
Open the pump filter at the bottom front
It is behind a panel and it is designed to be opened. Coins, sand and hair clips come out of it in that order.
-
03
Listen before ordering
A pump that hums and moves nothing has a jammed impeller. A pump that is silent has failed or is not being told to run.
Applies to
The Electrolux units we carry this work out on
-
Front load only · 300 to 700 Series Electrolux washer repair in Miami
Six machines, and every one of them is a front loader — 300, 400, 500, 600 and 700 Series plus a 24-inch compact. This make builds no top-load washer at all, which is the clearest single difference between this badge and the mass-market half of the same group. Laundry is the deep end of this line rather than an afterthought: 22 machines across washers, dryers and towers against six refrigerators. The maker publishes eight washer codes with real procedures behind them, and — worth knowing before you are quoted — three of those eight are installation problems rather than failures.
- Six washers, all front-load, 300 through 700 Series plus a 24-inch compact
- No top loader is built on this badge at all
- Three of the eight published codes are installation problems, not failures
In more detail
About Electrolux washer drain pump replacement
Nobody opens the pump filter
Every front loader of this generation has one behind a small panel at the bottom front, and it is meant to be opened by the owner every few months. Almost none are. In a coastal household washing beach towels it collects sand as reliably as lint, and a pump that has been working against a loaded filter for two years is a pump that will fail early. Opening it takes five minutes and a towel, and it is the first thing we do.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about Electrolux washer drain pump replacement
What comes out of it?
Coins, hair clips, sand and the occasional screw. In this region sand is the one people do not expect and the one that does the damage.
This maker says to check the hose first. Why?
Because it is right. A machine pushed back so a louvered closet door will shut folds its own drain hose, and the symptom then appears weeks after an installation that was perfectly good on the day.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name